Space Border - Prepasted

Space Border - Prepasted Wallpaper

Take your childs room to the realms of outer space with this fantastic Space pre-pasted border! A colourful solar system design for any child who loves outer space, this wallpaper will set imaginations flying to the planets and comets illustarted in the design!

The Outer Space Wall Stickers would be a great addition to this pre-pasted wall border!

HANGING INSTRUCTIONS

SURFACE PREPARATION: Walls should be smooth, dry, free from dirt and grease. Walls must be
sealed with paint or suitable wall primer, allowed to dry, then sized .

• Starting in an inconspicuous corner, measure a distance 112 inch less than the width of the paper,and make a plumed vertical line to the right of the corner. Then measure distance from ceiling tobaseboard, add 4 inches, and cut a strip of material equal to that length.
• Roll cut strip loosely with pattern side in., top up. Soak in warm water for 30 seconds. Remove and fold paste-ta-paste and allow strip to set for 3 minutes.
• Carry the wallcovering to the wall. Place the right edge of strip along the vertical line on wall.
  Allow the remainder of the strip to go into and around corner.
• Smooth out bubbles using a soft smoothing brush. Trim top and bottom with a straight edge
  and razor knife. Wipe each strip immediately after hanging using clean water and a sponge.
• Using pattern match at baseboard and ceiling as a reference, determine the length of your next
  strip, allowing extra for trimming then follow step #2 above.
• Slide the next strip into position with its edge butted against the edge of the proceeding strip.
  Do not overlap seams. Gently roll butted seam with a seam roller. Be sure to match design
  of the adjacent strips at eye level.
  

Note: Reverse hang strips of wallcoverings on random matched textures.

Dimensions:

Approximately 4.57m long by 26cm wide

How many Borders will I need?